Laptop Stand

[MG Jennings]

Thanks everyone....I ended up getting a Jotto and am happy with the simplicity and apparent quality. My main concern was a mount that allowed comfort and room for a passenger & airbag safe....it appears to fit the bill.

 

[JustinRudicel]

Any have a Hyundai Santa Fe and have a laptop stand for it? I'm trying to make a decision with budget in mind which would work the best for me. Seat bolts are great but with the Santa Fe they're angled and not flat on the floor board. So it makes securing the stand a little tricky. Any suggestions on the best route to go without drilling holes in my car.

 

[David Wolfson]

Justin, is it possible to use a short length of holed steel strip -- available from home improvement and hardware stores -- bent with a vise or pliers to adjust for the angle? Some variety of that approach should work, I think.

 

[Adam Simone]

Well damn I ended up ordering a Jeniko last week and got it today and of course I can't get the screws out of the seats in my truck to install it. Trying to figure out other ways to install it to make it still work. Oh well I guess, next time before I order something I better be damn sure I can use it right.

 

[rob.cannon]

Well damn I ended up ordering a Jeniko last week and got it today and of course I can't get the screws out of the seats in my truck to install it. Trying to figure out other ways to install it to make it still work. Oh well I guess, next time before I order something I better be damn sure I can use it right.

I actually just bought a RAM POD III universal, they don't make a custom for my car. I had a Jeniko, but I got sick of the wobble it had.

Try an impact, but low torque.